sanding wheel on die grinder, then whetstone to flatten.

new shaft seal.

After sanding.

 

The fuel pump.

The vacuum pump.

 

$34.95

 

Well done. Keep up the good work!

 

this dude never gives up. Tremendous resolve. I could never do something like this.

 

Nice Just did this. Pretty straight forward...

 

What size torx did you use to get the screws out of the fuel pump side? T25 is too big, T20 is a bit loose and I stripped two of the screw heads. I cannot find any torx bits between those two sizes. I have the same repair kit you used but the replacement screws for the fuel pump side have heads that are too thick (too tall); they are not the rounded heads shown in your kit.

I think I'll just replace the seal and not disassemble it any further.