After my FOB Key 'De-Programmed' itself I couldn't open my TREG (with one key)
The dealer told me it would cost $50-60.00 to reprogram OR if that didn't work a new key would be $469.00 + the reprogramming cost!
I found the DIY reprogramming information on the following website;
VW Remote Fob Programming Guide: | autokeysquad.co.uk
VW:
VW Volkswagen Step-by-Step FREE Fob programming guide:
Remote Control Programming (1997 ON)
Procedure:
1. Switch Ignition ON and leave the key in the ignition.
2. Mechanically lock the vehicle using the Drivers door using a second
key.
3. Using the remote control press the Unlock button once, and the horn
will sound once.
4. Wait 6 seconds and press the unlock button once to activate the coding
procedure. The remote control will now be programmed.
NOTE : When performing programming on additional remotes the procedure
is the same, except you press the unlock button 2, 3 or 4 times for the
different remote.
For example : If programming 2 remotes press the unlock button twice with
a 1 second interval between each press, repeat for 3 and 4 remotes.
5. Switch Ignition OFF.
6. Remove key from ignition and check for operation.
7. The coding procedure can be repeated up to 4 times for additional remotes.
8. The ignition must be switched OFF between programming each remote
control.
It took all of forty (40) seconds to program the faulty FOB Key and saved me $$$$$$$
The dealer told me it would cost $50-60.00 to reprogram OR if that didn't work a new key would be $469.00 + the reprogramming cost!
I found the DIY reprogramming information on the following website;
VW Remote Fob Programming Guide: | autokeysquad.co.uk
VW:
VW Volkswagen Step-by-Step FREE Fob programming guide:
Remote Control Programming (1997 ON)
Procedure:
1. Switch Ignition ON and leave the key in the ignition.
2. Mechanically lock the vehicle using the Drivers door using a second
key.
3. Using the remote control press the Unlock button once, and the horn
will sound once.
4. Wait 6 seconds and press the unlock button once to activate the coding
procedure. The remote control will now be programmed.
NOTE : When performing programming on additional remotes the procedure
is the same, except you press the unlock button 2, 3 or 4 times for the
different remote.
For example : If programming 2 remotes press the unlock button twice with
a 1 second interval between each press, repeat for 3 and 4 remotes.
5. Switch Ignition OFF.
6. Remove key from ignition and check for operation.
7. The coding procedure can be repeated up to 4 times for additional remotes.
8. The ignition must be switched OFF between programming each remote
control.
It took all of forty (40) seconds to program the faulty FOB Key and saved me $$$$$$$
