Club Touareg Forum banner
1 - 2 of 2 Posts

· Registered
2015 CVVA V6TDi 4XMotion (262HP)
Joined
·
45 Posts
Hello everybody.
I needed your help because I'm new to this subject and I do not have the necessary knowledge.
Recently i bought a steering wheel to replace the one in my car because this steering wheel has more functions. Like the existing one, this steering wheel has a module in the center where the radio controls, the lane assist vibrator motor and the gearbox levers are connected.
Assuming this module is not protected, is it possible to transfer all the settings, adaptations, coding, etc with VCDS or VAG CAN from the old module to the new one? If so, how is it done?
 

· Registered
2015 CVVA V6TDi 4XMotion (262HP)
Joined
·
45 Posts
That unit inside steering wheel is just switching module, which is not accessible with VCDS. Everything coded in 16-Steering wheel contains unit which is together with slip ring.
So, you don't have to copy coding, just adjust it after replacing steering wheel to get all functions.
Thanks.
 
1 - 2 of 2 Posts
Top