So I'm inserting the headlight crank tool as we speak into the hex bolt. I'm twisting it towards the proper direction of travel, as per the label in the engine bay, to "open" it, but I'm being greeted with quite a bit of resistance on my hand. I'm too scared to twist any harder.
First question. How many complete revolutions(if any at all), does it normally take, in order for the headlight assembly to partially push out? Maybe I'm just not twisting hard and/or far enough into the cycle?
As I wait for an answer here, I sprayed that area with some WD-40, to loosen things up a bit, in case they are slightly seized.
EDIT: Just realized I forgot to post this in the Problem/Bugs section of the forum.
First question. How many complete revolutions(if any at all), does it normally take, in order for the headlight assembly to partially push out? Maybe I'm just not twisting hard and/or far enough into the cycle?
As I wait for an answer here, I sprayed that area with some WD-40, to loosen things up a bit, in case they are slightly seized.
EDIT: Just realized I forgot to post this in the Problem/Bugs section of the forum.
