Please post your actual codes from that controller, just like you did from the engine module above.

 

Have you checked for 5v across two of the 3 pins at the height sensor connector? Could be a wiring issue. Why did you replace the compressor and air spring assembly?

 

We're abouts is that fuse bud ?

 

#partscanon

 

00778,01437,01769
Steering angle sensor G85
01437 control position not learned 005
01769 sensor for vehicle leevling ,front right G289 ,014 defective
Hi people im at whits end with this I've replaced all the fuses and as many relays and the front right level control sensor and shock absorber and air compressor. Any help would be much appreciated I have no air in the front airbags even if I could get a way to recode it because I can't get the security access to work for the adaptation in level control to work it View attachment 252879 View attachment 252880 View attachment 252882 View attachment 252883
[/QUOTE

I've checked all the fuses bud like 3 times so many fuses .i replaced the air compressor and front right strut because they were old and worn .cheers guys any help is mch appreciated

 

Owners manual or google will tell you, should be on the right end of the dash. Total of 3 I believe.

 

I'm pretty sure it's the level control unit I pulled it out of the car and started it and all the warnings didn't come up also there must be a broken wire from the right front sensor to the control unit that il have to find because I've replaced that sensor twice this is a pic of inside the level control from the back of the car im not sure what the discolouration is anybody know where i can buy on in Australia? Suspension Control Module Volkswagen Touareg 2004 7l6907553b OEM

 

It might be worth trying to clean that circuit board with acetone and a soft toothbrush to remove that discolouration before obtaining a new module, as it could be causing the problem. Nothing to lose if it doesn't work. Do both sides.

 

I sprayed it with maf sensor spray and it's a really hard tary residue but im hearing you I might just have to be a bit more aggressive with it .

Cheers bud

 

It looks like it may be Flux. I wonder if someone has tried to repair it before and not cleaned it off? Alternative is conformal coating except you would expect that to be all over the board. I be very careful with what you clean it with. First suggestion would be to pop into Jaycar and pick up some circuit board cleaner. Electronic Circuit Board Cleaner Spray Can | Jaycar Electronics

 

It looks like it may be Flux. I wonder if someone has tried to repair it before and not cleaned it off? Alternative is conformal coating except you would expect that to be all over the board. I be very careful with what you clean it with. First suggestion would be to pop into Jaycar and pick up some circuit board cleaner. Electronic Circuit Board Cleaner Spray Can | Jaycar Electronics

Hi , I made the same thing and replaced the same parts and finally was broken wires in the right side of the door .

 

Alright guys I got it sorted ,it was the right front sensor but I just installed it didn't clear the dtc codes also there was one very corrioded wire I resoldered. The wire was where the front water builds up behind the front right wheel drivers side

in Australia passenger side USA

 

Well done.

Always good when people report the fix!

 

Love how well your oversized tires work!