Club Touareg Forum banner
1 - 10 of 10 Posts

Peanuttree

· Registered
Joined
·
52 Posts
Discussion starter · #1 ·
I get my Vag com cable in two days and I wanted to know how to do the Transmission ROW mod. If someone could post the instructions on how to set it up that would be amazing.

As a side question has there been a conclusion on whether or not lowering the air suspension by 1 inch (25MM) would mess up the cambers.

Thank you very much everyone!
 
Both of these topics are covered in threads with in this forum. Run a search and you will come up with the answers you need. Both are more then likely in the DIY or VAG Com sections of the forum.
 
Discussion starter · #3 ·
Care of evolvingpowercat:

Thought I would give this a try, too and see how I like it.
For those who asked about the VAG-COM details:

Before:

Address 02: Auto Trans Labels: 09D-927-750.lbl
Part No: 09D 927 750 EA
Component: AL 750 6A 0899
Coding: 0004216
Shop #: WSC 25642 444 68437

After:

Address 02: Auto Trans
Protocol: KWP2000
Part No: 09D 927 750 EA
Component: AL 750 6A 0899
Coding: 0004200
Shop #: WSC 25642



Would I just enter this in like the after: is listed, is there any trick to it?
 
In the coding, delete the last two digits (the "16") and type in "00" in its place. It's as easy as that.
 
Discussion starter · #5 ·
In the coding, delete the last two digits (the "16") and type in "00" in its place. It's as easy as that.
Great, thank you very much! I excited to do this because since getting my 2005 touareg I have noticed a small jolt in some gears.
If I do this do I still need to ask the VW dealership for a transmission flash? What does the flash cost?
 
Great, thank you very much! I excited to do this because since getting my 2005 touareg I have noticed a small jolt in some gears.
If I do this do I still need to ask the VW dealership for a transmission flash? What does the flash cost?
The coding will help it a little, but won't make it better. You more then likely have a valve body going out in the tranny. Does it exhibit arough 4-5 shift? If so that is the valve body and the coding won't fix it. There were software updates for the tranny as well. You need to check if it was performed on that vehical.
 
Discussion starter · #7 ·
It's more when on 1 and 2, and it may just be my imagination,because of how it shifts, sometimes there's no sense to it. It's not really as smooth as I'd hope. So with the transmission update will the dealership charge me?
 
Greetings, rudolf here, I've purchased an 04 v10, loaded out of Auburn Washington, and enjoy every cruise. While searching this site I've discovered a 'update tranny' option. Can someone direct me where to get this update, and how to install 'said' software.
cheers!
 
Greetings, rudolf here, I've purchased an 04 v10, loaded out of Auburn Washington, and enjoy every cruise. While searching this site I've discovered a 'update tranny' option. Can someone direct me where to get this update, and how to install 'said' software.
cheers!
Software update is from the dealer only. Can't do that yourself since you can't get access to it at all. It was a TSB on the older T1 trannys. You just need to go to the dealer to see if it was ever performed.
 
1 - 10 of 10 Posts