[thecurtmaster]

Hey all, I can't seem to figure out how to work my garage Homelink system. I've followed the instructions per the owner's manual, and once I get to step 4, nothing happens at all. Any help would be greatly appreciated. 08 T2.

 

[thecurtmaster]

It probably means you have a rolling code garage door; this is good because a crafty burglar can't sniff your opener and play it back to gain access.

If you move on to the next page, there are instructions for that as well. It requires a second person to push the training button on the opener at the same time.

Thank you for that, but I also have an electric gate on the same opener. Would that also be rolling code or something else? Both don't seem to work.
Thanks,
Curt

 

[thecurtmaster]

The trick might be the "holding down the buttons long enough" part. When training my Homelink I have to hold the garage remote button down continuously for a lot longer than usual. Eventually Homelink learns the code.

I just attempted to just hold it down until it works, but it flashes slowly from the beginning, then just stops flashing altogether. It doesn't flash rapidly as the manual said it would.