[JimJ]

I am installing a 7" monitor for a wireless camera in where the console storage compartment is located. The wireless camera is fitted to the back of my trailer sailer so that I can monitor traffic behind me.

As the Treg came with an aftermarket reversing camera I can also use the video feed from the reversing camera for the video 2 on the monitor. The video lead for this has been routed to the back of the Delta radio which I have now re-routed to where the storage compartment was.

At some stage a different radio head with reversing camera, phone and GPS Nav has been fitted and replaced with the original Delta radio before I bought the vehicle.

Problem is that I need 12v in where the console storage compartment is.

Is there any 12v connectors or 12v cables in this area that I can utilise for the power?

 

[JimJ]

I ran a 12v power from the right side fuse box.

That was one source I was looking at as the reversing camera cable is routed down the "a-pillar" and into the dash next to the fuse box.

 

[JimJ]

You also have a 12v source just a few inches forward with the 12v power outlet by the shifter...

If I can get into the back of the 12v outlet that would be OK. Just have to figure out how to get to it and route the lead up past the radio stack.

In the meantime, I can plug into that outlet and run a lead externally to the monitor.