Club Touareg Forum banner

Search results

1-20 of 137 Results
Advanced Search
  1. Brakes replaced - grinding noise

    Brakes, Steering, Suspension, Wheels and Tires
    Apologies for not getting back to you regarding the brake story. So I took all the wheels off again, loosened the callipers and torqued them back to spec making sure they were perfectly aligned. The situation got better over the next few days and now, 4'000km later I'm glad to report no issues...
  2. 00778 (G85) & steering play

    Brakes, Steering, Suspension, Wheels and Tires
    Hi all, Recently had my front diff out to change the bearings. Dropped the subframe to do this. Now everything's been put together but the car throws an error through VCDS: Steering Angle Sensor (G85) 004 - No Signal/Communication - Intermittent Tried clearing it but it comes back. There also...
  3. My T1 Front Differential Rebuild

    Engine, Transmission and Exhaust
    Sweet, just what I was looking for, @TRespect . Thanks!!!
  4. Seized front rotors?!

    Brakes, Steering, Suspension, Wheels and Tires
    I recommend anyone facing the problem to watch this video:
  5. Brakes replaced - grinding noise

    Brakes, Steering, Suspension, Wheels and Tires
    Nope, plus I bled the brakes a week ago.
  6. Brakes replaced - grinding noise

    Brakes, Steering, Suspension, Wheels and Tires
    Ok, will redo it tomorrow. Keep you posted!
  7. My T1 Front Differential Rebuild

    Engine, Transmission and Exhaust
    To what specs should you torque the three bolts holding the front diff on the subframe?
  8. Brakes replaced - grinding noise

    Brakes, Steering, Suspension, Wheels and Tires
    Thanks for checking up on that, @QPower1 ! How I installed them: after cleaning the hub I set the new rotors on and "torqued down the single Torx screw to 15nm (spec). To the best of my knowledge all four disk are installed properly. There doesn't seem to be any dirt between the rotors and the...
  9. Brakes replaced - grinding noise

    Brakes, Steering, Suspension, Wheels and Tires
    I appreciate the offer, @QPower1 , but I can't put in a call right now. The parts are: BREMBO P 85 065 (pads) BREMBO P 85 070 (pads) BOSCH 0 986 479 095 (x2 - rotors) BOSCH 0 986 479 251 (x1 - rotors) BOSCH 0 986 479 249 (x1 - rotors) What do you think is the issue?
  10. Brakes replaced - grinding noise

    Brakes, Steering, Suspension, Wheels and Tires
    So I let them spin for a few seconds and this is the result. I also hit the brakes a couple of times. Is this normal?!
  11. Brakes replaced - grinding noise

    Brakes, Steering, Suspension, Wheels and Tires
    Hi all, Just replaced front + back pads & rotors and now they make a grinding noise. Tested it on jack stands without the wheels on and it sounds like 3 out of 4 wheels are rubbing. I found the new pads to be an extremely tight fit in the calipers. Putting the car in drive while on jack stands...
  12. Seized front rotors?!

    Brakes, Steering, Suspension, Wheels and Tires
    Broken loose using a pair of screws to act as jacks through the brake caliper bracket!
  13. Seized front rotors?!

    Brakes, Steering, Suspension, Wheels and Tires
    Hi all, Currently replacing the front rotors (did the rear a couple of days ago). It seems the rotors have seized onto the hub. No matter how hard I hit them with a hammer or how much WD40 I spray, they won't budge... Anyone else experience this? Thanks! VD-CH
  14. Brake flush 2004 V10

    Brakes, Steering, Suspension, Wheels and Tires
    Euh... Sorry. Maybe I wasn't clear in my post. I'm talking about the brake fluid which needs to be replaced every 2 years.
  15. Front diff backlash???

    Engine, Transmission and Exhaust
    Hi everyone, I've just replaced my left and right bearings on my front diff. One was obviously scratched. Before I proceed with reassembling the entire unit I wanted to check something with you. The mechanic (brought him my diff crown to replace the bearings for me) told me I'd have to check...
  16. Correct torque for front diff

    Brakes, Steering, Suspension, Wheels and Tires
    Hi all, What the correct torque for the bolts holding the front diff housing together? What about the torque for the three bolts keeping the diff on the subframe? Thanks! Best, VD-CH
  17. Brake flush 2004 V10

    Brakes, Steering, Suspension, Wheels and Tires
    Hi everyone, Shamefully, my brakes haven't been flushed in way too long. I just replaced all the pads and rotors so I should do so now. Empty the reservoir, top it up with new fluid, run the ABS bleed program and then do the two-person bleed method? Missing anything for the Touareg? How much...
  18. LM503349 - LM503310 vs KLM503349 - KLM503310

    Engine, Transmission and Exhaust
    Hi, I pulled out my diff bearings today and noticed they're (KLM503349 - KLM503310) whereas I just ordered LM503349 - LM503310... I know the difference is that the measurements are metric (KLM) vs imperial (LM)... Biggie? The guy in the video seems to have done the same and I noticed a number...
  19. Dropping the front diff

    Engine, Transmission and Exhaust
    SUCCESS! A two ton cable puller didn't do the trick... A can of WD40, a good old steel hammer and some anger & frustration did it! Thanks guys!
  20. Dropping the front diff

    Engine, Transmission and Exhaust
    Worry not, that's what I've already exposed my neighbors to over the past several weeks!
1-20 of 137 Results
Top